Test Drive: "Tailor" Dynamic Equalizer from Hit Design

There are other aspects of the Tailor that should interest your station's engineers should the unit be considered for the transmitter chain. The Tailor is a series equalizer as opposed to a parallel equalizer. This eliminates many phase error problems that occur with parallel equalization. Regarding the control signal, we'll quote the manual: "The Tailor sums the outputs together and passes this summed signal through each bandbass filter for each octave center. Each band has its own individual detector and time constants. These constants have been factory selected and optimized for each band. This resultant signal is then routed through the equalizer gain control section. The control signal is connected to both left and right channels. Therefore, both channels track identically, both in gain and control."

In response to why the Tailor doesn't have separate control signals for left and right channels, we quote once more: "...using one control voltage keeps the information change in the control voltage identical from left to right. If separate control voltages were used, several things would occur. First, unless the time constants were EXACTLY the same, one channel would have a different time constant than the other. This would create "aliasing" from left to right. The attack/release time in one channel would be slightly different from the other channel. The effect would be anything from annoying to downright disastrous."

Each of the ten bands in the Tailor has independent attack and release times that were carefully selected and preset at the factory. This eliminates additional controls on the front panel, and of course, reduces the cost of manufacturing the unit. As far as our ears could tell, the attack and release time settings were fine. Most attractive was the fact that fewer controls on the unit simply made it easier to use.

But why, you ask, all this engineering-type nonsense about the Tailor? The Tailor is unique in many ways, and once we hooked the unit up and started playing music through it, the advantages of using the Tailor in the transmitter chain became very obvious. It would be an injustice to the Tailor to not expose its value in this application. Let your engineers read this review if they don't usually read them. With all the efforts stations make to out-process one another, the Tailor should be a consideration in the search for processing tools.

"Fine," you say. "Now what about the Tailor in production?" Ahh, we're glad you asked. We saved the best for last. How many times have you received agency tapes with spots that needed further equalization? You get spots that don't have enough highs in them, spots with no low end, spots with too much low end, spots boosted so high in the upper mid-range frequencies that they jump right out at you when they're on the air. This boost in the upper mids is intentional so the spots will indeed jump out at you, but it doesn't make for very consistent sounding stopsets. The Tailor can fix this inconsistency.

Comments (0)

There are no comments posted here yet

Leave your comments

  1. Posting comment as a guest. Your post will be moderated. Your email address will not be shown or linked. (If you have an account, log in for real time posting and other options.)
0 Characters
Attachments (0 / 3)
Share Your Location